Edge banding machine is a machine with electrical automatic control and programmed operation. It should be carefully checked when purchasing. The main method is: first, listen to the manufacturer’s product introduction, from the specifications, performance, scope of use, operation method, price, service, etc. of the machine, so as to have a general perceptual understanding of the required machine. Second, look at the outside of the machine in good condition. Check whether the parts and accessories are complete, watch the operation demonstration of the manufacturer’s demonstration personnel, see the bonding effect, and master the operation essentials of the machine. Three tests, open the machine for trial operation. Check whether the power supply and air supply lines are smooth and sensitive, and whether the main shaft of the main engine runs smoothly and without noise. On this basis, the user decides whether to buy or not.
Precautions
The main advantages of the curved line edge banding machine are that the bonding is firm, fast, light and efficient. elements such as the working environment and operating methods. When choosing an edge band, attention should be paid to factors such as width, thickness, material, toughness, and surface treatment. Hot melt adhesive should pay attention to the difference between high, medium and low temperature adhesives, match the type of edge banding, and scientifically set the heating control temperature, as well as the flowability and solidification delay of the sol. The selection of the base material also has the requirements of quality, temperature, parallelism and perpendicularity of the cut surface. The indoor temperature and dust concentration of the working environment also need to be considered. The operation speed, pressure, balance, Continuity, etc. will affect the edge sealing effect. Fourth, the maintenance method of the curved line edge banding machine There will also be some problems and failures in the use of the curved line edge banding machine. The common failures are:
1. Electrical failure. Including the main engine stall, the heating is not fast, the program is disordered, etc., if not eliminated in time, the motor and heating tube will be burned, and even the entire mechanical system will be damaged. During maintenance, mainly check the electrical control box, motor, heating tube, delay device, etc. This kind of maintenance is generally repaired by professionals or by the manufacturer.
2. Gas circuit failure. Including air valve failure, air leakage, low air pressure, cutter, feeding not working, etc., mainly check the integrity of various pneumatic components, replacement parts can be carried out under the guidance of the manufacturer’s technicians.
3. Mechanical failure. Mainly include transmission failure, uneven gluing, feeding failure and cutter failure, etc., mainly check the integrity and firm parts of each mechanical component, and whether the transmission part is offset.
4. Bonding failure. Such as non-stick, deviation, entrainment, etc., this is a comprehensive fault, related to the glue shaft, edge band, sol, substrate and operation. This kind of failure may occur alternately or singly, and the specific maintenance depends on the situation.
Post time: Jan-21-2022
